1997 - 2001 GM (Vans) 3 Button Keyless Entry Remote w/o Anti-Theft - ABO0204T

1997 Chevrolet Venture
1997 Oldsmobile Silhouette
1997 Pontiac Trans Sport

1. Remove key from ignition switch.
2. Remove the MALL PGM fuse, from fuse box
3. Close all doors.
4. Turn ignition switch to ACC.
5. Within 1 second turn the ignition switch to OFF then back to ACC
6. Open and close drivers door.
7. A chime will sound indicating you are in programming mode.
8. Press and hold the LOCK and UNLOCK buttons together until chime sounds twice, about 14 seconds.
9. Repeat step 8 for any additional remotes.
10. Remove key from ignition and replace MALL PGM fuse.
11. Test remotes.

If the above instructions do work try these. It seems to depend on production date which one works.

1998 - 2001 Chevrolet Venture
1998 - 2001 Oldsmobile Silhouette
1999 - 2001 Pontiac Montana
1998 Pontiac Trans Sport

1. Remove key from ignition.
2. Remove the “BCM PRGRM” fuse from the fuse panel, accessed by opening the front passenger door. Use the legend on the fuse panel to properly locate the “BCMPRGRM” fuse.
3. Close all of the doors.
4. Close the liftgate.
5. Insert keys into the ignition, and turn the ignition lock cylinder to ACC (one click towards you – the opposite direction from starting the engine).
6. Turn the ignition lock cylinder to OFF, and then back to ACC within 1 second.
7. Open and close any vehicle door. A chime will be heard when the system enters the programming mode.
8. Press and hold the transmitter LOCK and UNLOCK buttons simultaneously for 14 seconds. IMPORTANT: After 7 seconds, a chime may be heard confirming successful synchronization. It is necessary to wait approximately 14 seconds for a second chime that will confirm successful programming. Your new remote has been accepted and all existing remote codes have been erased.
9. Repeat the previous step on each additional transmitter to be programmed (including any existing transmitters).
10. Remove the ignition key from the ignition lock cylinder.
11. Install the “BCM PRGRM” fuse back into the fuse panel.