*NEW OEM* 2010 - 2016 Toyota Transponder Key 'G' Chip - TOY44GPT

Please contact us via phone (1-855-224-7258 EXT-3) or live support chat to the bottom right of our website to confirm programming for this product. Our techs will make sure you know everything you need to!

If our techs inform you that this product needs to be programmed by a Locksmith

The two following vehicles are self programmable. All other vehicles must be programmed by an automotive locksmith. 2011 Toyota Highlander and 2010 Toyota Tundra.

2011 Toyota Highlander
1. Enter vehicle and close all doors
2. Insert master Toyota key in and out of ignition cylinder 4 times. On the 5th time leave the master key in the ignition cylinder
3. Open and close driver’s side door 6 times
4. Remove master key from ignition cylinder.
5. Verify that security light on the information display is solid, indicating that the car successfully entered programming mode
6. Insert new transponder chip key
7. Watch security light blinking for about 60 seconds
8. When security light goes out, your new key should be successfully programmed
9. Remove new key from the ignition cylinder
10. To verify that your new key is able to deactivate anti-theft system: security indicator light on the information display should disappear when inserting properly programmed key into ignition cylinder
11. If programming is unsuccessful start over at step 1

2010 Toyota Tundra
Add Duplicate Key
Requires one working Toyota Master Key.

1. Make sure all doors and windows are closed.

2. Insert Master key into the ignition cylinder.

3. Cycle the ignition cylinder from On to OFF five times.

4. Open and close the driver side door 6 times.

5. Remove the Master key and insert the new duplicates key.

6. TURN THE IGNITION CYLINDER ON.

7. The new key will be registered after 60 seconds. The THEFT light on the dashboard will go out, indicating that programming has been completed.


To delete all but one key from the System
1. Simultaneously depress and release brake and accelerator pedals 1 time.

2. Insert an existing master key into the ignition cylinder. Do not turn the key from the OFF (LOCK) position.

3. Within fifteen seconds of inserting the key, depress and release the accelerator pedal six times.

4. Within twenty seconds of completing the above step, depress and release the brake pedal seven times.

5. The security light will flash, indicating all keys other than the one being used have been deleted.

6. Remove the key from the ignition cylinder within ten seconds. It will be the only key still programmed to work.