1989 - 1996 Buick 3 Button Keyless Entry Remote Fob - ABO0116T

Dealer price: $126.25

Your price: $27.99

You Save: $98.26

That's 77.83% OFF dealer price!

In stock
1989 - 1996 Buick 3 Button Keyless Entry Remote Fob - ABO0116T

1989 - 1996 Buick 3 Button Keyless Entry Remote Fob - ABO0116T

**This item may or may not come with a Buick logo depending on availability**

Fits:

1991 - 1996 Buick Century
1989 - 1990 Buick Park Avenue
1989 - 1996 Buick Regal
1991 - 1996 Buick Roadmaster
1992 - 1996 Buick Skylark

 

Battery: 2 X 2016

Product Specs and Programming Information
SKU 937
FCC Number ABO0116T
OE Part # 12522337, 12522338, 88959920
Support Your purchase gives you 100% free e-mail and phone technical support from our expert staff.
180 Day Satisfaction Guarantee! If you are not 100% satisfied, you may return the product within thirty days of receipt for a refund. Please see our return policy for further info.
Programming Information This remote comes with self programming instructions. You can view them under the 'Programming Instructions' tab.
Product Condition Refurbished
Programming Instructions

1993 - 1996 Buick Century

1989 - 1996 Buick Regal
1991 - 1996 Buick Roadmaster
1992 - 1996 Buick Skylark

1.  Locate the green programming connector located in the LH trunk. Trim may
     have to be pulled back to access programming connector. ( Connector
     has wires leading up to it and it is not connected to anything.)

2.  Jump programming connector terminals.

3.  System should now lock and unlock doors and trunk lid to indicate 
      programming mode has been entered. Trunk lid must have activated
      before proceeding.

4.  Press any button on keyless remote once.
     System should now lock and unlock doors and trunk lid, indicating 
     successful programming of keyless remote. Trunk lid must have
     activated before proceeding. 

5.  Repeat step 4 for additional remote or other existing keyless remote.


1989 - 1990 Buick Park Avenue

 

Obtain all remote transmitters for this vehicle.

 

1. Ensure ignition is in the OFF position.

 

2. Lower glove box and remove the inner compartment. You must access behind the glove box. Once removed look in the upper left end and locate the Programming Connector. It will be a plastic connector with two terminals and two wires leading to it. Connector may be retained by a clip.

 

3. Once located jump the two terminals in the connector with a suitable jumper wire or you can use a paper clip bent in a "U" shape. Once connected properly the vehicle will automatically cycle the door locks to lock and then unlock.

 

4. Vehicle is now in programming mode. Press the UNLOCK button once on the first remote to be programmed. Vehicle will cycle door locks again to lock then unlock to verify acceptance of the remote.

 

5. Repeat step 4 to program an additional remote.

 

6. Programming is now complete. Remove jumper wire from Programming Connector and test remotes to ensure proper programming.


 

msrp $126.25
Copyright © 2019-present Replacemyremote.com All rights reserved.