1991 - 1995 Pontiac Bonneville 3 Button Keyless Entry Remote Fob - ABO0302T

1991 - 1995 Pontiac Bonneville 3 Button Keyless Entry Remote Fob - ABO0302T

1991 - 1995 Pontiac Bonneville 3 Button Keyless Entry Remote Fob - ABO0302T

1991 - 1995 Pontiac Bonneville 3 Button Keyless Entry Remote Fob - ABO0302T
Dealer Price $126.25 Your Price $17.00 You save $109.25 That's 86.53% OFF dealer price!
Availability: In stock
SKU
940

1991 - 1995 Pontiac Bonneville 3 Button Keyless Entry Remote Fob - ABO0302T

**This Remote has A Pontiac OEM Logo.**

Fits:

1991 - 1995 Pontiac Bonneville

More Information
SKU940
FCC NumberABO0302T
OE Part #256022667
SupportYour purchase gives you 100% free e-mail and phone technical support from our expert staff.
180 Day Satisfaction Guarantee!If you are not 100% satisfied, you may return the product within thirty days of receipt for a refund. Please see our return policy for further info.
Programming InformationThis remote comes with self programming instructions. You can view them under the 'Programming Instructions' tab.
Product ConditionRefurbished
Programming Instructions

1991 - 1992 Pontiac Bonneville  

 

1.     Locate the Data Link Connector (DLC) underneath the driver's side dashboard.
Use the figure as a map for your DL ( They are not lettered on your vehicle.)
The view is looking straight into the cavities of the DLC.

 

2.     Connect cavity G with cavity A using a fused jumper wire.
Your vehicle will respond by locking and unlocking the door locks within 2 seconds.

 

3.     Press any button 3 times in successtion on first remote to be programmed.
Locks will lock and unlock verifying remote was programmed.

 

4.     Press any button 3 times in succession on second remote to be programmed if applicable.
Locks will lock and unlock to verify remote was programmed.

 

5.     Remove jumper wire and test remote(s)



1993 - 1995 Pontiac Bonneville

1.   Insert key in ignition and leave in the OFF position

2.    Locate the Data Link Port. It is located under dash drivers side. Be sure you know
     
which pins are 8 and 4.   

      (Note port is wider at top) Your OBDII port will not
          have numbers, use this diagram for reference.
 

  

   

 


 




3.     
Make sure there are metal contact pins in terminals 8 and 4. Connect 8 to 4 with a 
        suitable
 jumper wire (leave the jumper
wire connected throughout the programming
        procedure).
Make sure you know which terminals are 8 and 4. The vehicle will respond
       
by locking and unlocking the doors to signify entering of programming mode.


4.    Close doors.

5.   Turn ignition to the ON position (as far as you can go without cranking the engine).
      Doors will lock. 

6.      Press and hold both the LOCK and UNLOCK buttons together on the first transmitter to
       be
 programmed. After about 15 seconds, the vehicle will respond by locking and
       unlocking the doors. 
Release the buttons on the transmitter.

7.      Within one minute, repeat the previous step on the remaining transmitters to be
      
programmed.

8.    Remove jumper wire applied to th OBDII Port.


msrp126.25