1993 - 1997 Chrysler/Dodge 3 Button Keyless Entry Remote - GQ43VT7T

Dealer price: $79.99

Your price: $17.99

You Save: $62.00

That's 77.51% OFF dealer price!

In stock
1993 - 1997 Chrysler/Dodge 3 Button Keyless Entry Remote - GQ43VT7T

1993 - 1997 Chrysler/Dodge 3 Button Keyless Entry Remote - GQ43VT7T

Fits:

1993 - 1997 Chrysler Concorde
1993 - 1997 Dodge Intrepid

Product Specs and Programming Information
SKU 581
FCC Number GQ43VT7T
OE Part # 04759136AB
Support Your purchase gives you 100% free e-mail and phone technical support from our expert staff.
180 Day Satisfaction Guarantee! If you are not 100% satisfied, you may return the product within thirty days of receipt for a refund. Please see our return policy for further info.
Programming Information This remote comes with self programming instructions. You can view them under the 'Programming Instructions' tab.
Product Condition Refurbished
Programming Instructions

Obtain all remote transmitters for this vehicle.

1. Remove the middle vent bezel from the center of the dashboard. Locate the 6 pin traction control connector behind the vent. It will be black in color. Connector should be connected to the vent bezel or the traction control switch, if connected to the traction control switch you must unplug it.

2. Insert key into ignition and turn ignition switch to the ON position.

3. Using a jumper wire or a paper clip bent in the shape of a "U" jump pin 1 to pin 4. Ensure there are metal contacts or pins in cavities 1 and 4. When done properly the doors will automatically lock and then unlock to show that vehicle is in programming mode.

4. Press any button on the first remote to be programmed. Locks will cycle again to indicate vehicle recognized remote. If programming a second remote press any button on second remote to be programmed, locks will cycle again to indicate that second remote was recognized.

5. Programming is now complete, turn ignition to OFF position, remove jumper wire, and test remotes to ensure proper programming.

 

- OR -

dlc-port-1-16.jpg

 

Obtain all remote transmitters for this vehicle.

1. Insert key into ignition and turn ignition switch to the ON position. (Turn as far as you can without cranking the engine)

2. Locate the Data Link Connector (DLC). It will be under the dash on the drivers side. Use the diagram above to identify pins 1 and 4. Notice that the DLC connector is tapered. You can use this to help identify the proper pins. Using a suitable jumper wire jump pin 1 to pin 4. Ensure that there are metal connector ends in the cavities that are referenced in this procedure. Once the jumper wire is installed it needs to remain there throughout this process until instructed to remove.

3. Press any button on the first remote to be programmed. If the signal is recognized the vehicle will Lock then Unlock the doors automatically.

4. Repeat step 3 for any additional remotes to be programmed. The doors will again Lock then Unlock automatically after each successful remote programming.

5. Remove jumper wire and remove key from ignition as programming is complete. Test each remote to ensure proper programming.

msrp $79.99
Copyright © 2019-present Replacemyremote.com All rights reserved.