1999 - 2001 Honda Prelude 2 Button Keyless Entry Remote Fob - CWT72147KA3

1999 - 2001 Honda Prelude 2 Button Keyless Entry Remote Fob - CWT72147KA3
Dealer Price $129.99 Your Price $128.39 You save $1.6 That's 1.23% OFF dealer price!
Availability: In stock
SKU
952

1999 - 2001 Honda Prelude 2 Button Keyless Entry Remote Fob - CWT72147KA3

OE: 72147-S30-A01

Fits:

1999 - 2001 Honda Prelude

180 Day Satisfaction Guarantee!

If you are not 100% satisfied with your product for any reason, you may return the product within 180 days of ordering for a replacement. Please see our return policy for further information.

 

More Information
SKU952
FCC NumberCWT72147KA3
OE Part #72147-S30-A01
SupportYour purchase gives you 100% free e-mail and phone technical support from our expert staff.
Programming InformationThis remote comes with self programming instructions. You can view them under the 'Programming Instructions' tab.
Product ConditionRefurbished
Programming Instructions

 If your Prelude has Dealer Installed System.

 Note:
 Entering the programming mode cancels all learned keyless remotes, so none
 of the previously programmed remotes will work.  You must reprogram all of the
 keyless remotes once you are in the programming mode.

 You must complete each step within 5 seconds  of the previous step to keep the
 system from exiting  the programming mode.

 1. Turn ignition switch to ON (II)

 2. Press the LOCK or UNOCK button on one of the remotes. (An unprogrammed 
     remote can be used for this step.)

 3. Turn ignition switch to LOCK (0)

 4. Repeat steps 1, 2 and 3 two more times using the same keyless remote used
     in step 2

 5. Turn the ignition switch to ON (II)

 6. Press the LOCK or UNLOCK button the same remote.  Make sure the power door
     locks cycle to confirm you are in programming mode.

 7. Press the LOCK or UNLOCK button on each remote you want to program. Make
     sure door locks cycle after you push each remote button to confirm system has
     accepted the remote.

  8. Turn the ignition switch to LOCK (0) to exit programming mode.

  9. Test remote(s)   


 If  your Prelude has Factory Installed System

 Note:
 This system will accept up to three remotes. The remotes are stored in a
 stacking-type memory. If a fourth remote is programmed  the first remote
 will be erased.

 1. Turn ignition switch to ON (II)

 2. Within 4 seconds  press the LOCK or UNOCK button on one of the remotes.
     Make sure remote is aimed at the receiver near the glove box.

 3. Within 4 seconds turn ignition switch to LOCK (0)

 4. Repeat steps 1, 2 and 3 two more times using the same keyless remote used
     in step 2

 5. Within 4 seconds turn the ignition switch to ON (II)

 6. Within 4 seconds press the LOCK or UNLOCK button the same remote.  Make
     sure the power door locks cycle to confirm you are in programming mode.
     Press the LOCK or UNLOCK button again.

 7. Press the LOCK or UNLOCK button on each remote you want to program. Make
     sure door locks cycle after you push each remote button to confirm system has
     accepted the remote.

  8. Turn the ignition switch to LOCK (0) to exit programming mode.

  9. Test remote(s)

msrp129.99