2005 - 2009 NEW Replacement Chrysler, Dodge, Jeep 4 Button Remote Head Key w/ Transponder - KOBDT04A

Dealer Price $206.95 Your Price $48.14 You save $158.81 That's 76.74% OFF dealer price!
Availability: In stock
SKU
551-A
  • Buy 2 for $43.33 each and save 10%
  • Buy 3 for $40.92 each and save 15%

2005 - 2009 NEW Replacement Chrysler, Dodge, Jeep 4 Button Remote Head Key w/ Transponder - KOBDT04A

Fits:

2005 - 2008 Chrysler 300
2007 - 2009 Chrysler Aspen
2006 - 2007 Dodge Charger
2006 - 2007 Dodge Durango
2005 - 2008 Dodge Dakota
2006 - 2007 Jeep Commander
2005 - 2007 Jeep Grand Cherokee

IMPORTANT: To ensure you're purchasing the correct key, please verify with an existing remote key that there is a screw holding the back piece on.

180 Day Satisfaction Guarantee!

If you are not 100% satisfied with your product for any reason, you may return the product within 180 days of ordering for a replacement. Please see our return policy for further information.

 

More Information
SKU551-A
FCC NumberKOBDT04A
OE Part #Dodge: 56038749AB Chrysler: 56038757AB Jeep: 56038768AB
SupportYour purchase gives you 100% free e-mail and phone technical support from our expert staff.
Programming InformationThis remote comes with self programming instructions. You can view them under the 'Programming Instructions' tab. You must have Two working keys (keys that start your car) to perform this procedure.
Product ConditionNew Aftermarket
Programming Instructions

Obtain all remote transmitters for this vehicle.

 

You must have Two working keys (keys that start your car) to perform this procedure.


1. Cut the new key to match existing keys.


2. Insert the first valid key into the ignition switch. Turn the ignition switch to the ON position for at least three seconds, but no longer than 15 seconds. Then, turn the ignition switch to the LOCK position and remove the first key.


3. Insert the second valid key into the ignition switch. Turn the ignition switch to the ON position within 15 seconds. After 10 seconds, a chime will sound. In addition, the vehicle security light will begin to flash. Turn the ignition switch to the LOCK position and remove the second key.


4. Insert a blank key into the ignition switch. Turn the ignition switch to the ON position within 60 seconds. After 10 seconds a single chime will sound. In addition, the vehicle security light will stop flashing. To indicate that programming is complete, the vehicle Security light will turn on again for three seconds and then turn off.


5. The new key is now programmed. The remote Keyless Entry transmitter will also be programmed during this procedure.


6. Repeat this procedure to program up to eight keys.


Please refer to your owners manual if you are uncertain of the location of Lock and or On.

msrp206.95