1998 - 2006 Chrysler, Dodge, Jeep, Plymouth Transponder Key - Y160-PT

You must have two valid keys to add a new key to the system!

Note: If you do not have 2 valid working keys you will have to call a
          Locksmith to program or originate a key for you.

1. Insert the first valid key into the ignition switch. Turn the ignition switch to the
    ON/RUN position for at least three seconds, but no longer than 15 seconds.
    Then, Turn the ignition switch to the LOCK position and remove the first key.

2. Insert the second valid key into the ignition switch. Turn the ignition switch to
    the ON/RUN position within 15 seconds. After 10 seconds, a chime will sound.
    In addition, the Vehicle Security Light will begin to flash. Turn the ignition switch
    to the LOCK position and remove the second key.

3. Insert the new key into the ignition switch. Turn the ignition switch  to the
    ON/RUN position.within 60 seconds. After 10 seconds, a single chime will
    sound. In addition, the Vehicle Security Light will stop flashing. To indicate that
    programming is complete, the Vehicle Security Light will turn on again for
    seconds and then turn off.

   The new key is now programmed. The Remote Keyless Entry transmitter will
   also be programmed during this procedure.

   Repeat this procedure to program up to eight keys.