2000 - 2001 Nissan/Infiniti 3 Button Keyless Entry Remote Fob - KBRASTU10-MODEL/01A

Dealer Price $149.99 Your Price $101.64 You save $48.35 That's 32.24% OFF dealer price!
Availability: In stock

2000 - 2001 Nissan/Infiniti 3 Button Keyless Entry Remote Fob - KBRASTU10-MODEL/01A

*Please verify your number is MODEL/01A and NOT MODEL/A. If you have MODEL/A you will need SKU: 6708


2001 Nissan Frontier
11/2000 - 07/2001 Nissan Pathfinder
2001 Nissan Xterra

You may be sent a Nissan or Infiniti remote, the logo on the item doesn't affect the programming of the item in any way.


180 Day Satisfaction Guarantee!

If you are not 100% satisfied with your product for any reason, you may return the product within 180 days of ordering for a replacement. Please see our return policy for further information.


More Information
OE Part #28268-2W602
SupportYour purchase gives you 100% Free email and phone technical support service from our expert staff.
Programming InformationThis remote comes with self programming instructions. You can view them under the 'Programming Instructions' tab.
Product ConditionRefurbished
Programming Instructions

IMPORTANT: Before entering programming mode, have in possession all of the transmitters you will be using on the vehicle. Once you program the transmitter, all previous codes will be erased from the memory. The other transmitters will not be functional until you program the transmitters again.  

1.   Close and lock all doors with the driver’s side power lock/unlock switch.

2.   Insert key into ignition and remove it from the ignition key cylinder at least six times within 10 seconds. Your Hazard
     Lamps will flash if you have performed this step successfully. NOTE: Withdraw key completely from ignition cylinder
      each time. If this procedure is performed too fast, system will not enter programming mode.

3.   Insert key into the ignition cylinder and turn to the ACC position.

4.   Within 5 seconds, push ANY button on the remote transmitter. Your Hazard Lamps should flash. NOTE: Do not press
     the button more than one time in the above step. If the button is pressed more than one time, the programming
     procedure will not be successful.

5.   If there are any remaining transmitters (including the old ones), unlock then lock all doors using the driver’s side
     power lock/unlock switch and within 5 seconds, push ANY button on the next remote. Your Hazard Lamps should
     flash. Repeat this step for each transmitter (including any existing transmitters).

6.   Turn the key to the OFF position, remove keys from the ignition, unlock doors using the driver’s side power lock/unlock switch and open the driver side door.