2000 - 2002 Infiniti G20 4 Button Keyless Entry Remote Fob - KBRASTU10 - Model /A

2000 - 2002 Infiniti G20 4 Button Keyless Entry Remote Fob - KBRASTU10 - Model /A
Your Price $84.99
Availability: Out of stock

2000 - 2002 Infiniti G20 4 Button Keyless Entry Remote Fob - KBRASTU10 - Model /A

*IMPORTANT* Your current remote has a Model number on the back of it. You MUST match this up with the replacement remote. This unit's model is: Model /A. For Model /01A click here

Production after 06/2000 only


2000 - 2002 Infiniti G20

180 Day Satisfaction Guarantee!

If you are not 100% satisfied with your product for any reason, you may return the product within 180 days of ordering for a replacement. Please see our return policy for further information.


More Information
OE Part #28268-7J107
SupportYour purchase gives you 100% free e-mail and phone technical support from our expert staff.
Programming InformationThis remote comes with self programming instructions. You can view them under the 'Programming Instructions' tab.
Product ConditionRefurbished
Programming Instructions
  1. Close and lock all doors with the driver's side power lock / unlock switch located on drivers door panel.
  2. Insert key into ignition (DON'T TURN) and remove it from the ignition key cylinder at least 6 times within 10 seconds (this will need to be done at approximately one second intervals). Your hazard lamps will flash if you have performed this step correctly. PLEASE NOTE: Withdraw key completely from ignition cylinder each time. If this procedure is performed too fast or too slow the system will not enter programming mode.
  3. Insert key into ignition and turn to the ACC position.
  4. Within 5 seconds, push the LOCK button on the keyless remote. Your hazard lamps will flash. PLEASE NOTE: Do not press the button on the remote more than one time or the programming will not be successful.
  5. If there are any remaining remotes (including working ones), Unlock then Lock all doors using the switch on drivers door panel. Within 5 seconds of locking and unlocking doors press LOCK button on the next remote. Your hazard lamps will flash. Repeat this step for each remote (including any working remotes).
  6. When all remotes have been programmed turn the key to the OFF position, remove keys from the ignition, unlock doors using the driver’s side power lock/unlock switch and open the driver side door. Test all remotes.