2002 - 2005 GM 5 Button Keyless Entry Remote Fob w/ Dual Sliding Doors - L2C0007T
Fits:
2002 - 2005 Chevrolet Venture
2002 - 2004 Oldsmobile Silhouette
2002 - 2004 Pontiac Montana
If you are not 100% satisfied with your product for any reason, you may return the product within 180 days of ordering for a replacement. Please see our return policy for further information.
SKU | 942 |
---|---|
FCC Number | L2C0007T |
OE Part # | 10335587, 10335582-88 |
Support | Your purchase gives you 100% free e-mail and phone technical support from our expert staff. |
Programming Information | This remote comes with self programming instructions. You can view them under the 'Programming Instructions' tab. |
Product Condition | Refurbished |
Programming Instructions | 2001 - 2005 Chevrolet Venture 2001 - 2005 Pontiac Montana IMPORTANT: Before entering programming mode, have in possession all of the remotes you 1. Remove the key from the ignition. 2. Remove the "BCM PRGRM" fuse from the fuse panel. Use the legend on the fuse panel to 3. Close all of the doors. 4. Close the liftgate. 5. Insert the key into the ignition, and turn to the ACC position. 6. Turn the key to OFF and then back to ACC within 1 second. 7. Open and close any vehicle door. A chime will be heard when the system enters into 8. Press and hold the remote LOCK and UNLOCK buttons simultaneously for 14 seconds. 9. Repeat step 8 now for each additional remotes to be programmed including any existing 10. Remove key from ignition. 11. Install the "BCM PRGRM" fuse back into the fuse panel and test remote(s). 2001 - 2004 Oldsmobile Silhouette 1. Remove key from ignition. 3. Close all of the doors. 5. Insert keys into the ignition, and turn the ignition lock cylinder to ACC (one click towards you – the opposite direction from starting the engine). 7. Open and close any vehicle door. A chime will be heard when the system enters the programming mode. 8. Press and hold the transmitter LOCK and UNLOCK buttons simultaneously for 14 seconds. IMPORTANT: After 7 seconds, a chime may be heard confirming successful synchronization. It is necessary to wait approximately 14 seconds for a second chime that will confirm successful programming. Your new remote has been accepted and all existing remote codes have been erased. 9. Repeat the previous step on each additional transmitter to be programmed (including any existing transmitters). 10. Remove the ignition key from the ignition lock cylinder. 11. Install the “BCM PRGRM” fuse back into the fuse panel. |