2002 - 2011 OEM Honda Civic/Element 3 Button Keyless Entry Remote Fob - OUCG8D-344H-A

Dealer Price $129.99 Your Price $64.19 You save $65.8 That's 50.62% OFF dealer price!
Availability: In stock

IMPORTANT: There are 3 pictures above that show three different cases the item may come in. In all scenarios, the board inside is 100% complete original Honda. If you're looking for a remote with the original Honda logo please call to confirm we have it in stock. Because this remote is 15+ years old, it is incredibly rare to find a remote in iti's original casing that is in good condition. This is why 99% of the time the OEM electronics are re-cased into a new aftermarket case. Also, 2009 - 2011 Honda Element is not self programmable and you will need a locksmith in your area to program it in for you.


2002 - 2005 Honda Civic (SI models only)
2003 - 2008 Honda Element

180 Day Satisfaction Guarantee!

If you are not 100% satisfied with your product for any reason, you may return the product within 180 days of ordering for a replacement. Please see our return policy for further information.


More Information
FCC NumberOUCG8D-344H-A
OE Part #72147-S5T-A01
SupportYour purchase gives you 100% free e-mail and phone technical support from our expert staff.
Programming InformationMOST models come with self programming instructions. You can view them under the 'Programming Instructions' tab. All other models will need an automotive locksmith to come out and program the unit in for you. NOTE: When looking under the 'Programming Instructions' tab please look for your specific model as the programming instructions vary.
Product ConditionRefurbished
Programming Instructions

2002 - 2005 Honda Civic (SI models only)
2003 - 2008 Honda Element

Obtain all remote transmitters for this vehicle and read the instructions prior to programming.

Entering programming mode will erase all previously programmed remotes for this vehicle. You must have all remotes available for programming including working ones.

  • Enter vehicle and close all doors
  • Each of the following steps must be completed within five seconds of completing the previous step. If you take longer than five seconds or make a mistake, you must start the entire procedure over.
  • Insert the key into the ignition, hold one remote in your left hand with additional remotes close by. We recommend taking remotes off the key ring to perform the procedure. When the instructions say to press the LOCK button, you should press the LOCK button on the remote for approximately one second then release it.

Perform each of the next three steps in order, then repeat all three steps two more times for a total of three times each.

  1. Turn the ignition to the ON position, marked II.
  2. Press the LOCK button on the remote.
  3. Turn the ignition to the OFF position, marked I. (Do steps 1-3 three times)

Next, turn the ignition switch to ON position, marked II.

     4. Using the same remote, press the LOCK button again. The door locks should cycle indicating the vehicle has ENTERED programming mode.

     5. Using the same remote, press the LOCK button again. The door locks should cycle indicating the vehicle has PROGRAMMED that remote.

If you have other remotes to program then repeat step 5 with each additional remote one after another. Step 5 must be completed within ten seconds for each additional remote. You may program up to three remotes.

     6.  Turn the ignition to OFF. Test all remotes.

If your remote has a trunk button you will need to hold that button down for several seconds for that function to operate.