2003 - 2007 Toyota 4 Button Keyless Entry Remote Fob - ELVATDD

Dealer price: $149.99

Your price: $62.99

You Save: $87.00

That's 58% OFF dealer price!

In stock
2003 - 2007 Toyota 4 Button Keyless Entry Remote Fob - ELVATDD

2003 - 2007 Toyota 4 Button Keyless Entry Remote Fob - ELVATDD

Fits:

2003 - 2007 Toyota 4-Runner
2003 - 2007 Toyota Sequoia

Product Specs and Programming Information
SKU 6617
FCC Number ELVATDD
Support Your purchase gives you 100% free e-mail and phone technical support from our expert staff.
180 Day Satisfaction Guarantee! If you are not 100% satisfied, you may return the product within thirty days of receipt for a refund. Please see our return policy for further info.
Programming Information This remote comes with self programming instructions. You can view them under the 'Programming Instructions' tab.
Product Condition Refurbished
Programming Instructions

1. Start with key out of ignition, drivers door is open all others closed and 
    drivers door is unlocked.

2. Insert key into the ignition (Do NOT Turn) and Pull key out.

3. Perform these steps within 40 seconds.
    A. Using the power lock switch on the drivers door, perform 5 lock/unlock cycles
        starting with lock. Use an even pace and try to go about one cycle per second.
        (1Cycle  = 1 lock and 1 unlock).
    B. Close, then open drivers door.

4. Perform these steps within 40 seconds.
    A. Using the power lock switch on the drivers door, perform 5 lock/unlock cycles
        starting with lock. Use an even pace and try to go about one cycle per second.
         (1Cycle  = 1 lock and 1 unlock).
    B. Insert the key in the ignition cylinder.
    C. Turn the ignition to ON (Do NOT Start) then back to OFF.
    D. Remove the key from the ignition.

5. Within 3 seconds the power door locks should cycle automatically indicating successful
    entry into programming mode. Return to step 1 if the locks do not cycle at this point.

6. Perform these steps within 40 seconds.
    A. Press the lock and unlock buttons on the remote simultaneously for 1 second.
    B. Immediately after letting go of the lock and unlock buttons, press the lock button by
        itself and hold for 2 seconds. Within 3 seconds, the door locks should cycle once
        indicating successful programming. If the door locks do not cycle, or cycle twice.
        repeat steps A and B in step 6 as your remote has not been accepted.
    C. Repeat steps A and B in step 6 for each new remote.

7. Close drivers door.

msrp $149.99
Copyright © 2019-present Replacemyremote.com All rights reserved.