2005 - 2007 Saab 2 Button Keyless Entry Remote Fob - A269ZUA111

Please contact us via phone (1-855-224-7258 EXT-3) or live support chat to the bottom right of our website to confirm programming for this product. Our techs will make sure you know everything you need to!

If our techs inform you that this product needs to be programmed by a Locksmith, you may do Google search here for 'automotive locksmith' followed by your zip code. We suggest calling Locksmiths to find the best rate for the programming and/or cutting service.

Programming:
ALPINE REMOTE CONTROL / RE LED LIGHT

1. Close all doors, trunk, and hood.
2. The security system must be in "disarm" mode. The key must be removed from the ignition key slot.

Enter Code-Learning Mode
3. Open the trunk and leave it open.
4. Open the driver's door and sit in the driver's seat.
5. Close the driver's door.
6. Cycle the ignition switch 5 times between the "off" position and position 2 (ignition "ON", all dash warning lamps will illuminate)
6b. Remove the key from the ignition. The red status LED will illuminate continuously, and the siren will "chirp" once, to indicate that the code-learning mode has been initiated.

DO NOT START THE ENGINE

The ignition switch cycling in step #6 must be performed within ten seconds.

The sequence in steps #1-6 must be performed within 45 seconds.

Registering/Delete ID Code(s)
7. Open driver's door, (remain seated in driver's seat)
8. Close driver's door.
9. Press and release any button on the remote you wish to register into the system. The status LED will shut off momentarily to indicate that one ID code has been registered.
10. Repeat steps 7 through 9 to register the remaining three ID codes.

Exiting Code-Learning Mode
11. Open driver's door, and exit from vehicle, leaving the door opened.
12. Close trunk.
13. Close driver's door. The LED will turn off and the siren will "chirp" twice.
14. The initialization procedure is now completed, test all remotes to confirm operation.