2000 - 2008 Dealer Installed Mazda 4 Button Keyless Entry Remote Fob - GOH-PCGEN2

The following programming instructions will ONLY work on the following models and years:

2004 - 2008 Mazda 3

2000 - 2002 Mazda 626

2007 - 2008 Mazda CX-7

2000 - 2002 Mazda Millenia

2000 - 2003 Mazda Protoge

If you have a model and a year that is not listed above then you'll need to contact an automotive locksmith in your area to come out and program the remote in. The cost for remote programming will vary depending on your location.

1. Get in vehicle and close all doors, then open the drivers door and leave it open.

2. Within 24 seconds you must insert key into the ignition and cycle the ignition switch to ON and then OFF three times and leave the key in the ignition. Then close and open the drivers door three times.

3. When done properly the doors will automatically lock and then unlock. Now the vehicle is in programming mode. If locks do not cycle you must start the procedure over.

4. Push any button twice on the first remote to be programmed. The door locks will cycle automatically to indicate successful programming. If there is only one remote to be programmed to the vehicle you must push any button twice again on the same remote, wait for locks to cycle, then push any button twice one more time on the same remote. If there are two remotes to be programmed then press any button on the second remote twice, wait for locks to cycle, then push any button twice again on the second remote. To program three remotes to this vehicle you must press button twice on second remote, wait for locks to cycle, then press any button twice on the third remote.

5. Programming is now complete. Close the door and test remotes to ensure proper programming.