2006 - 2016 OEM GM 5 Button Keyless Entry Remote Fob w/ Remote Start/Trunk OUC60221, OUC60270

Please contact us via phone (1-855-224-7258) or live support chat to the bottom right of our website to confirm programming for this product. Our techs will make sure you know everything you need to!

If our techs inform you that this product needs to be programmed by a Locksmith, you may do Google search here for 'automotive locksmith' followed by your zip code. We suggest calling Locksmiths to find the best rate for the programming and/or cutting service.

2011-2012 Buick Lucerne – Not Self-Programmable, will require a Locksmith to program

2010 Chevrolet Equinox - Not Self-Programmable, will require a Locksmith to program

2011-2016Chevrolet Impala- Not Self-Programmable, will require a Locksmith to program

2008-2012 Chevrolet Monte Carlo - Not Self-Programmable, will require a Locksmith to program

The following vehicles are Self-Programmable:

2006 - 2010 Buick Lucerne
2006 - 2007 Cadillac DTS
2006 - 2010 Chevrolet Impala
2006 - 2007 Chevrolet Monte Carlo

Use this Procedure for Vehicles with 
Driver Information Center Buttons

This information is in your Owners Manual in the 
Drivers Information Center Section.

1. Insert Key and turn to ON position so you can access Driver Information Center
   
   2. Press the vehicle information button until
       PRESS TO RELEARN REMOTE KEY displays 
   
   3. Press the set/reset button until 
       REMOTE KEY LEARNING ACTIVE displays
   
   4.  Press and hold the lock and unlock buttons on the keyless remote at the same 
        time for approximately 15 seconds. A chime will sound indicating that the remote is 
        programmed.
   
   5.  To program additional remotes at this time repeat step 4.
         This vehicle can have a maximum of eight remotes programmed.
2. To exit programming mode turn key off and remove key.
        Test remote(s).

Use this Procedure for Vehicles without
Drivers Information Center Buttons

To access this display, the vehicle must be in Park (P) with key in the on position (as far
    as you can go without cranking engine)

1. Press the trip odometer reset stem until RELEARN REMOTE KEY displays. 

2. Press and hold the trip odometer reset stem for three seconds.
       The message REMOTE KEY LEARNING ACTIVE  will display 
3. Press and hold the lock and unlock buttons on the first keyless remote at the same 
        time for approximately 15 seconds. A chime will sound indicating that the remote is 
        programmed.
4. To program additional remotes at this time repeat step 3. 
        This vehicle can have a maximum of eight remotes programmed.
5. To exit programming mode turn key off and remove key.
        Test remote(s).