2006 - 2017 NEW GM 4 Button Keyless Entry Remote w/ Remote Start - OUC60270, OUC60221

Vehicle made AFTER 2010 are NOT self programmable

2007 - 2010 Buick Enclave
2010 Cadillac Ext
2007 - 2010 Chevrolet Avalanche
2008 - 2010 Chevrolet Express
2007 - 2010 Chevrolet Silverado
2008 - 2010 Chevrolet Suburban
2007 - 2010 Chevrolet Tahoe
2007 - 2010 Chevrolet Traverse
2007 - 2010 GMC Acadia
2008 - 2010 GMC Savana
2007 - 2010 GMC Sierra
2008 - 2010 GMC Yukon

PROCEDURE #1
THIS PROCEDURE IS FOR VEHICLES WITH THE DRIVER INFORMATION CENTER. IT WILL BE A BUTTON TO THE RIGHT OF THE STEERING WHEEL WITH A VEHICLE ICON AND THE LETTER i.

1.Insert key and switch the ignition ON (just shy of starting vehicle without cranking engine)

2. Press vehicle information button until PRESS TO RELEARN REMOTE KEY is displayed.

3. Press the set/reset button (button will have a checkmark) until REMOTE KEY LEARNING ACTIVE is displayed. Vehicle is now in programming mode.

4. Press and hold LOCK and UNLOCK buttons at the same time on first remote for approximately 15 seconds. An acoustic signal will be heard indicating successful programming.

5. Repeat step 4. to program additional remotes. You can have up to 8 programmed remotes for this vehicle. You must program ALL remotes including existing remotes.

6. To exit programming mode turn ignition OFF, remove key and test all remotes.

PROCEDURE #2
THIS PROCEDURE IS FOR VEHICLES WITHOUT THE DRIVERS INFORMATION CENTER.

1. Insert key into the ignition and turn to ON (Just shy of starting vehicle without cranking engine).

2. Press the trip odometer reset button until RELEARN REMOTE KEY is displayed.

3. Press and hold the trip odometer reset button for approximately 3 seconds until REMOTE KEY LEARNING ACTIVE displays.

4. Press and hold LOCK and UNLOCK buttons at the same time on first remote for approximately 15 seconds. An acoustic signal will be heard indicating successful programming.

5. Repeat step 4. to program additional remotes. You can have up to 8 programmed remotes for this vehicle. You must program ALL remotes including existing remotes.

6. To exit programming mode turn ignition OFF, remove key and test all remotes.

2007 - 2010 Saturn Outlook

PROGRAMMING WITH DRIVER INFORMATION CENTER

1: Switch ignition ON.

2: Press vehicle information button (located just to the right of the steering wheel) until PRESS TO RELEARN REMOTE KEY is displayed.

3: Press set/reset button (located just to the right of the steering wheel, will have a checkmark on it) until REMOTE KEY LEARNING ATIVE is displayed.

4: Programming mode now activated. Press and hold LOCK and UNLOCK buttons on the first remote for 15 seconds. When that remote is programmed an acoustic tone will be heard.

5: Repeat step 4 for any other additional remotes.

6: To exit programming mode switch ignition to off and then test all remotes.

PROGRAMMING WITHOUT DRIVER INFORMATION CENTER

1: Switch ignition on.

2: Press trip/odometer reset button (upper left of instrument cluster) until RELEARN REMOTE KEY is displayed.

3: Press and hold trip/odometer reset button for 3 seconds, REMOTE KEY LEARNING ACTIVE will be displayed.

4: Vehicle now in programming mode. Press and hold LOCK and UNLOCK buttons on first transmitter for 15 seconds

5: When an audible tone is heard first remote is programmed. Repeat step 4 for any other remotes.

6: To exit programming mode just switch key off.