2006 - 2012 Toyota/Scion 3 Button Remote Head Key w/o chip - HYQ12BBY

2006 - 2012 Toyota/Scion 3 Button Remote Head Key w/o chip - HYQ12BBY

2006 - 2012 Toyota/Scion 3 Button Remote Head Key w/o chip - HYQ12BBY

2006 - 2012 Toyota/Scion 3 Button Remote Head Key w/o chip - HYQ12BBY
Your Price $53.00
Availability: In stock
SKU
2717

2006 - 2012 Toyota/Scion 3 Button Remote Head Key w/o chip - HYQ12BBY

Fits:

2009 - 2010 Toyota Corolla
2006 - 2010 Toyota Rav 4
2008 - 2012 Scion xB

More Information
SKU2717
FCC NumberHYQ12BBY
OE Part #89070-0R030 89070-12380
SupportYour purchase gives you 100% free e-mail and phone technical support from our expert staff.
180 Day Satisfaction Guarantee!If you are not 100% satisfied, you may return the product within thirty days of receipt for a refund. Please see our return policy for further info.
Programming InformationSOME models come with self programming instructions. You can view them under the 'Programming Instructions' tab. All other models will need an automotive locksmith to come out and program the unit in for you. The cost for key cutting/program will vary depending on your location.
Product ConditionRefurbished
Programming Instructions

This will program the remote portion of your key. You are going to want to take the key along with an existing one somewhere to get the cuts duplicated to the new blade before performing this programming procedure for the remote portion. 

2006-2007 RAV4

2008- 2010 XB

 

Obtain all remote transmitters for this vehicle.

 

1. Start with the key out of the ignition, drivers door is open, all other doors and trunk closed and drivers door is unlocked.


2. Perform these steps within 5 seconds. A. Insert the key into the ignition (Do NOT Turn it) and Pull key out. B. Insert the key into the ignition (Do NOT Turn it) and Pull key out.


3. Perform these steps within 40 seconds. A. Close then open the drivers door. B. Close then open the drivers door. C. Insert the key into the ignition (Do NOT Turn it) and Pull key out.


4. Perform these steps within 40 seconds. A. Close then open the drivers door. B. Close then open the drivers door. C. Insert the key into ignition and leave it in the ignition. D. Close the drivers door. E. Turn the ignition to ON (Do NOT Start or crank engine) then back to OFF. F. Remove the key from the ignition.


5. Within 3 seconds, the power door locks should lock then unlock automatically indicating successful entry into programming mode. Return to step 1 if the door locks do not cycle at this point.


6. Perform these steps within 40 seconds. A. Press the lock and unlock buttons on the remote simultaneously for 1.5 seconds. B. Immediately after letting go of the lock and unlock buttons, Press the lock button by itself and hold for 2 seconds. Within 3 seconds, the door locks should lock and then unlock once indicating successful programming. If the door locks cycle twice, repeat steps A and B in step 6 as the remote was not accepted. C. Repeat steps A and B in step 6 for each new remote.


7. Open drivers door.