2007 - 2014 Cadillac Escalade 6 Button Keyless Entry Remote w/ Remote Start - OUC60000223

2008 Cadillac Escalade

Use this Procedure for Vehicles with
Driver Information Center Buttons

This information is in your Owners Manual in the
Drivers Information Center Section.

1. Insert Key and turn to ON position so you can access Driver Information Center

2. Press the vehicle information button until
    PRESS TO RELEARN REMOTE KEY displays 

3. Press the set/reset button until
    REMOTE KEY LEARNING ACTIVE  displays

4.  Press and hold the lock and unlock buttons on the first keyless remote at the same
     time for approximatley 15 seconds. A chime will sound indicating that the remote is 
     programmed.

5.  To program additional remotes at this time repeat step 4.
      This vehicle can have a maximum of eight remotes programmed.

6.  To exit programming mode turn key off and remove key.
     Test remote(s).

Use this Procedure for Vehicles without
Drivers Information Center Buttons

To access this display, the vehicle must be in Park (P) with key in the on position (as far
    as you can go without cranking engine)

1. Press the trip odometer reset stem until RELEARN REMOTE KEY displays. 

2. Press and hold the trip odometer reset stem for three seconds.
    The message  REMOTE KEY LEARNING ACTIVE  will display 

3.  Press and hold the lock and unlock buttons on the first keyless remote at the same
     time for approximately 15 seconds. A chime will sound indicating that the remote is 
     programmed.

4.  To program additional remotes at this time repeat step 3.
     This vehicle can have a maximum of eight remotes programmed.

5.  To exit programming mode turn key off and remove key.
     Test remote(s).

2009-2010 Cadillac Escalade

This information is in your Owners Manual in the
Drivers Information Center Section.

1. Insert Key and turn to ON position so you can access Driver Information Center

2. Press the vehicle information button until
    PRESS TO RELEARN REMOTE KEY displays 

3. Press the set/reset button until
    REMOTE KEY LEARNING ACTIVE  displays

4.  Press and hold the lock and unlock buttons on the first keyless remote at the same
     time for approximatley 15 seconds. (On vehicles with memory recall seats, the first
     remote learned with match driver 1 and the second will match driver 2.)

     A chime will sound indicating that the remote is programmed.

5.  To program additional remotes at this time repeat step 4.
      This vehicle can have a maximum of eight remotes programmed.

6.  To exit programming mode turn key off and remove key.
     Test remote(s).