2008 - 2018 Dodge 4 Button Non-Prox Fobik Key w/ Remote Start - Emergency key included - IYZ-C01C
2008 - 2018 Dodge 4 Button Non-Prox Fobik Key w/ Remote Start - Emergency key included - IYZ-C01C
*This non-prox remote is not for a push-button-start vehicle*
Fits:
2008 - 2010 Dodge Charger
2011 - 2018 Dodge Durango
2008 - 2018 Dodge Grand Caravan
2009 - 2010 Dodge Journey
2008 Dodge Magnum
2009 - 2018 Dodge RAM
IMPORTANT: For 2013+ Dodge RAM, please ensure that your ordering the correct item by verifying the FCC ID on your remote. If you're unsure of where this is located, please contact us. The FCC ID for this item is IYZ-C01C. If the FCC ID of your existing remote is GQ4-53T, please click here.
180 Day Satisfaction Guarantee!
If you are not 100% satisfied with your product for any reason, you may return the product within 180 days of ordering for a replacement. Please see our return policy for further information.
| SKU | 673MTO |
|---|---|
| FCC Number | IYZ-C01C |
| OE Part # | OE Part # |
| Support | Your purchase gives you 100% free e-mail and phone technical support from our expert staff. |
| Programming Information | MOST models come with self programming instructions. You can view them under the 'Programming Instructions' tab. YOU MUST HAVE TWO WORKING FOBIX REMOTES TO USE THIS PROCEDURE. If you only have on Fobik or this remote/key is not self programmable for your specific vehicle you will need to locate a local locksmith to have this product programmed to your vehicle. The cost for key cutting/program will vary depending on your location. |
| Product Condition | Refurbished |
| Programming Instructions | 2008 - 2010 Dodge Charger Obtain all remote transmitters for this vehicle. THIS PROCEDURE FOR FOBIX KEY YOU MUST HAVE TWO WORKING FOBIX REMOTES TO USE THIS PROCEDURE
1. Insert first programmed key into ignition switch.
2. Switch ignition ON for at least 3 seconds but no longer than 15 seconds.
3. Turn ignition OFF and remove key.
4. Within 15 seconds insert second programmed key into ignition switch and turn ignition ON.
5. After 10 seconds an audible tone will be heard and immobilizer warning lamp will flash.
6. Turn ignition OFF and remove second programmed key.
7. Within 60 seconds insert non-programmed key into ignition switch and turn ignition ON.
8. After 10 seconds an audible tone will be heard and immobilizer warning lamp will illuminate for 3 seconds.
9. Switch ignition OFF.
10. Remove key.
11. Check operation of programmed key transmitter.
12. Repeat procedure for additional key transmitters if required (up to 8 key transmitters can be programmed). |
Same Day shipping on
Expedited ordered before 2pm.
180 day
replacement guarantee
ONLINE SUPPORT
Free chat, phone, and email support.
