2008 - 2016 Mitsubishi Lancer 4 Button Remote Head Key - MIT3 Blade - OUCG8D-625M-A

Please contact us via phone (1-855-224-7258 EXT-3) or live support chat to the bottom right of our website to confirm programming for this product. Our techs will make sure you know everything you need to!

If our techs inform you that this product needs to be programmed by a Locksmith, you may do Google search here for 'automotive locksmith' followed by your zip code. We suggest calling Locksmiths to find the best rate for the programming and/or cutting service.

2010- 2016  Mitsubishi Lancer

Step by Step How to Program Instructions: 

Use these instructions to program the key portion of your remote head key if you have two working keys. If you do not have two working keys to program this device you must have an automotive locksmith pair the new device to your vehicle.

You first must get key cut by a Locksmith.  

1. Insert an existing first (working) key into the ignition cylinder.
2. Turn the ignition cylinder ON (Without cranking the engine) for 5 seconds and back to OFF and remove the key.
3. Within 10 seconds, insert a second working key and turn to ON. The security light will flash twice. Switch ignition back to OFF and Remove key.
4. Within 10 seconds insert the New (unprogrammed) key and turn to ON.
5. The security light will light up for 3 seconds to indicate the new key has been successfully programmed.
6. Turn ignition to OFF and remote new programmed key. Repeat steps 4 and 5 to program additional keys if any. All new keys must be programmed within 30 seconds of removing second programmed key and security light flashing twice.
7. To exit programming mode: leave ignition switched ON for more than 30 seconds.

Use these instructions to program the remote portion of your remote head key 

1.  Locate the Data Port under drivers side dashboard usually located to the right of steering column.

2. Insert keys in ignition and leave in the OFF position.
3. Make sure there are metal contact pins in terminals 1 and 4 and connect the Data Port terminals 1 and 4 with a suitable jumper wire, leave the jumper wire connected throughout the programming procedure. Make sure you know which terminals are 1 and 4.
4. Within 10 seconds after connecting the jumper wire, press the Hazard Switch 6 times. Note: The doors will automatically lock and unlock once at this time indicating that the system is in the programming mode.
5. Press the LOCK  button on the remote to be registered three times within 10 seconds. Upon successful programming, the door will lock and unlock once.
6. Repeat step 5 with up to 4 remotes (including any existing remotes) within one minute. After completing each programming, the doors will lock and unlock once.
7. Disconnect the programming wire and remove the keys from the ignition.