2008 - 2013 Jeep 6 Button Non-Prox Fobik Key w/ Remote Start - Emergency key included - IYZ-C01C

Your Price $78.10
Availability: In stock
SKU
1156MTO

2008 - 2013 Jeep 6 Button Non-Prox Fobik Key w/ Remote Start - Emergency key included - IYZ-C01C

Ekey- 584

*This non-prox remote is not for a push-button-start vehicle*

Fits:

2008 - 2010 Jeep Commander
2011 - 2013 Jeep Grand Cherokee

180 Day Satisfaction Guarantee!

If you are not 100% satisfied with your product for any reason, you may return the product within 180 days of ordering for a replacement. Please see our return policy for further information.

 

More Information
SKU1156MTO
FCC NumberIYZ-C01C
OE Part #2701A-C01C
SupportYour purchase gives you 100% free e-mail and phone technical support from our expert staff.
Programming InformationSOME models come with self programming instructions. You can view them under the 'Programming Instructions' tab. All other models will need an automotive locksmith to come out and program the unit in for you. NOTE: When looking under the 'Programming Instructions' tab please look for your specific model as the programming instructions vary. YOU MUST HAVE TWO WORKING FOBIX REMOTES TO USE THIS PROCEDURE
Product ConditionRefurbished
Programming Instructions

2008 - 2010 Jeep Commander


Obtain all remote transmitters for this vehicle.

THIS PROCEDURE FOR FOBIX KEY

YOU MUST HAVE TWO WORKING FOBIX REMOTES TO USE THIS PROCEDURE

 

1. Insert first programmed key into ignition switch.

 

2. Switch ignition ON for at least 3 seconds but no longer than 15 seconds.

 

3. Turn ignition OFF and remove key.

 

4. Within 15 seconds insert second programmed key into ignition switch and turn ignition ON.

 

5. After 10 seconds an audible tone will be heard and immobilizer warning lamp will flash.

 

6. Turn ignition OFF and remove second programmed key.

 

7. Within 60 seconds insert non-programmed key into ignition switch and turn ignition ON.

 

8. After 10 seconds an audible tone will be heard and immobilizer warning lamp will illuminate for 3 seconds.

 

9. Switch ignition OFF.

 

10. Remove key.

 

11. Check operation of programmed key transmitter.

 

12. Repeat procedure for additional key transmitters if required (up to 8 key transmitters can be programmed).