2013 - 2018 OEM Ford 5 Button Smart Key - Emergency key included - M3N5WY8609/M3N5WY8610 - CJ5T

Please contact us via phone (1-855-224-7258) or live support chat to the bottom right of our website to confirm programming for this product. Our techs will make sure you know everything you need to!

If our techs inform you that this product needs to be programmed by a Locksmith

2013 - 2018 Ford Keyless Entry Remote Fob Smart Key Programming Instructions

Note:You can program a maximum of eight programmed keys to your vehicle. All eight must be intelligent access keys. You can program your own intelligent access keys to your vehicle. This procedure programs both the vehicle immobilizer keycode and the remote control to your vehicle.
You must have two previously programmed intelligent access keys inside your vehicle and the new unprogrammed intelligent access key readily accessible.

Make sure that the ignition is switched off before beginning this procedure. Make sure that you close all the doors before beginning and that they remain closed throughout the procedure. Carry out all steps within 30 seconds of starting the sequence. Stop and wait for at least one minute before starting again if you carry out any steps out of sequence.

1. Place the first programmed intelligent access key in the middle of the tray.

2. Press the push button ignition switch.

3. Wait five seconds and then press the push button ignition switch again.

4. Remove the intelligent access key.

5. Within 10 seconds, place a second programmed intelligent access key in the middle of the tray.

6. Press the push button ignition switch.

7. Wait five seconds and then press the push button ignition switch again.

8. Remove the intelligent access key.

9. Within 10 seconds, place the unprogrammed intelligent access key in the middle of the tray.

10. Press the push button ignition switch. Keep the ignition on for at least six seconds.

11. Remove the newly programmed intelligent access key.

Programming is now complete. Check that the remote control functions operate and your vehicle starts with the new intelligent access key. If programming was unsuccessful, wait 10 seconds and repeat steps 1 through 11.

2015 Ford Focus Keyless Entry Remote Fob Smart Key Programming Instructions

You must have two previously programmed keys and the new unprogrammed key readily accessible. If you do not have two previously programmed keys you will need a Locksmith to cut and program a second key.

Make sure that the ignition is switched off before beginning this procedure. Make sure
that you close all the doors before beginning and that they remain closed throughout the procedure. Carry out all steps within 30 seconds of starting the sequence. Stop and wait for at least one minute before starting again if you carry out any steps out of sequence.
Note:You can program a maximum of eight smart keys to your vehicle.

Read and understand the entire procedure before you begin.

1. Open the floor console storage compartment lid.

2. Remove the tray.

3. Place the first programmed smart key flat on the symbol at the bottom of the floor console storage compartment.

4. Press the push button ignition switch.

5. Wait five seconds and then press the push button ignition switch again.

6. Remove the intelligent access key.

7. Within 10 seconds, place a second programmed smart key flat on the symbol.

8. Press the push button ignition switch.

9. Wait five seconds and then press the push button ignition switch again.

10. Remove the smart key.

11. Within 10 seconds, place the unprogrammed smart key flat on the symbol.

12. Press the push button ignition switch.

Programming is now complete. Check that the remote control functions operate and
your vehicle starts with the new smart key.

If programming was unsuccessful, wait 10 seconds and repeat Steps 1 through 12.