2017 - 2019 Buick Lacrosse 5 Button Smart Remote w/ Trunk - Emergency Key Included - 433Mhz - HYQ4EA
EKey: 7493
Fits:
2017 - 2019 Buick Lacrosse
If you are not 100% satisfied with your product for any reason, you may return the product within 180 days of ordering for a replacement. Please see our return policy for further information.
SKU | 7449 |
---|---|
FCC Number | HYQ4EA |
OE Part # | 13508414 |
Support | Your purchase gives you 100% free e-mail and phone technical support from our expert staff. |
Programming Information | This remote comes with self programming instructions which you can view under the "Programming Instructions" tab above. |
Product Condition | Refurbished |
Programming Instructions | Programming with TWO Recognized Transmitters A new transmitter can be programmed to the vehicle when there are two recognized transmitters. To program, the vehicle must be off and all of the transmitters, both currently recognized and new, must be with you. 1. Place the two recognized transmitters in the cupholder. 2. Remove the key lock cylinder cap on the driver door handle. See Door Locks pg. 35. 3. Insert the vehicle key of the new transmitter into the key lock cylinder on the outside of the driver door and turn the key to the unlock position five times within 10 seconds. The Driver Information Center (DIC) displays READY FOR REMOTE #2, 3, 4 or 5. 4. Place the new transmitter into the transmitter pocket inside the armrest storage area. 5. Press ENGINE START/STOP. When the transmitter is learned, the DIC will show that it is ready to program the next transmitter. 6. Remove the transmitter from the transmitter pocket and press UNLOCK. To program additional transmitters, repeat Steps 3–5. When all additional transmitters are programmed, press and hold ENGINE START/STOP for 12 seconds to exit 7. Put the key back into the transmitter.
If two currently recognized transmitters are not available, follow this procedure to program up to eight transmitters. This feature is not available in Canada. This procedure will take approximately 30 minutes to complete. The vehicle must be off and all of the transmitters you wish to program must be with you. 1. Remove the key lock cylinder cap on the driver door handle. See Door Locks pg. 35. 2. Insert the vehicle key of the transmitter into the key lock cylinder on the outside of the driver door and turn the key to the unlock position five times within 10 seconds. 3. Wait for 10 minutes until the DIC displays PRESS ENGINE 4. Repeat Step 2 two additional times. After the third time, all previously known transmitters will no longer work with the vehicle. Remaining transmitters can be relearned during the next steps. The DIC display should now show READY FOR REMOTE #1. 5. Place the new transmitter into the transmitter pocket inside the armrest storage area. 6. Press ENGINE START/STOP. When the transmitter is learned the DIC will show that it is ready to program the next transmitter. 7. Remove the transmitter from the transmitter pocket and press UNLOCK. To program additional transmitters, repeat Steps 4–6. When all additional transmitters are programmed, press and hold ENGINE START/STOP button for 12 seconds to exit programming mode. 8. Put the key back into the transmitter. |
msrp | 179.89 |